Terms And Conditions

Gas Heating Service Contract

  • Clean and adjust all safety controls
  • Clean burners
  • Clean heat exchangers
  • Clean and adjust pilot assembly
  • Clean electronic spark ignition
  • Check the complete furnace cycle
  • Check the chimney base
  • Check for proper draft
  • Check vent pipe and draft diverter
  • Check for gas leaks in furnace
  • Check for cracked heat exchanger
  • Check controls
  • Check belt and adjust tension
  • Checkfilters
  • Check fan control
  • Check electrical connections
  • Check temperature rise 
  • Lubricate moving parts

Parts Covered

We Will Adjust, Repair, Or Replace The Listed Parts And Controls If They Fail As A Result Of Normal Use!

  • Blower
  • Blower bearing
  • Blower belt
  • Blower capacitor
  • Blower motor (up to 1/3 HP not EMC)
  • Blower Pulley
  • Blower switch
  • Draft Hood 
  • Drain valve 
  • Electrical system (from service switch)
  • Fan and limit control
  • Fan door switch
  • Fan sensor
  • Fantimer
  • Fusible line
  • Gas manifold
  • Gas regulator
  • Gas shut off valve 
  • Gauge (temp/press)
  • Gauge Glass (including washers)
  • Ignitor
  • Ignitor sensor
  • lgnitorwire
  • Main mono port burner
  • Main ribbon burner
  • Pilot assembly
  • Pilot tubing
  • Pressure switch
  • Pressure switches

Low water cut-offs and water feeder controls on boiler are not covered!

There is a $50.00 credit towards circuit boards, aquastats, ignition modules, gas valves, inducer motors and/or assembles, EMC blower motors, circulator pumps and maintenace kits required for yearly maintenace.


This gas house heater contract covers only the parts listed above. The contract does not cover heat exchanger or water heaters. It does not cover zone valves, venting, purging, draining and/or refilling of hydronic systems, or system piping. It does not cover work resulting from faulty system design or faulty nstallation, equipment that is not in good working order at the time contract ties effect, or damage caused by customer abuse, vandalism, fire, water, freezing, and other abnormal conditions. It does not cover blown fuses or tripped circuit breakers. We will not cover a part if it is no longer available through normal procurement practices. We reserve the right to reject coverage.

This contract covers:

  • Preseason inspection
  • Repair or replacement of covered parts
  • Labor to install covered parts

Interested? Fill Out The Form Below For More Information

Contact Us